Taylor C707

 Specifications
 Electrical 
One dedicated electrical connection is required. See the electrical chart 
for the proper electrical requirements. Manufactured to be permanently 
connected. Consult your local Taylor distributor for cord and receptacle 
specifications as local codes allow. 

Beater Motor 
One, 1.5 hp. 

Refrigeration System
One, 10,100 BTU/hr. R449A.  
Separate Hopper Refrigeration (SHR), one, 400 BTU/hr. R134a.  
(BTUs may vary depending on compressor used.)

Air-Cooled
Minimum 6” (152 mm) on both sides and place the back of the unit against 
a wall to prevent recirculation of warm air. Minimum air clearances must be 
met to ensure adequate airflow for optimum performance. 
Optional air discharge chute directs heated air exhaust upward.  
No clearance required on right side if air discharge chute is used. 

Water-Cooled
 Water inlet and drain connections out rear panel 3/8” FPT.

Accessories
 • Cone Dispenser
 • Decals - Vanilla or Flavor Burst Cone 
• Hopper Locks
 • Legs - Increase height of unit by 4-1/4” (108 mm) 
• Syrup Rail (front mount requires special cart with rear door)
 • Syrup Rail Kit (side mount) 

Options 
• Hopper Agitator 
• Top Air Discharge Chute (air-cooled only)
 • C201 Cart with Casters